, with parameterization as scalable, intersecting vectors. doi:10.1371/journal.pone.0133088.gnarrower, nevertheless

Aus KletterWiki
Wechseln zu: Navigation, Suche

Line-width measurements is usually made in conjunction with edge-to-skeleton measurements by Pamapimod getting a line segment on the opposing edge, title= a0023499 which is intersected by the vector produced involving the edge point and skeleton point of your previous step (shown in Fig 10C). doi:10.1371/journal.pone.0133088.gnarrower, nevertheless, the influence of pixel position can begin to slightly improve the measured LER, up to 0.five nm in our preceding work employing higher resolution (ca. one hundred,000x) BCP patterns. We mitigate this, in part, by smoothing both the centre line from the skeleton and the outer edge, even though constraining the positions of your edge points. Edge-to-skeleton distances are determined for all points around the smoothed line edge, matching using the nearest points (shown in Fig 10A) on the smoothed skeleton line title= jrsm.2011.110120 which satisfy: edge ?xskel ??slopeskel edge ?yskel ??0 ??As derived from the dot item of the vector on the edge-to-skeleton distance as well as the orthogonal vector (1, slope) in the skeleton at that point, an interpolated point on the skeleton may be obtained (shown in Fig 10B). Line-width measurements is often created in conjunction with edge-to-skeleton measurements by discovering a line segment on the opposing edge, title= a0023499 which can be intersected by the vector made amongst the edge point and skeleton point from the earlier step (shown in Fig 10C). The solution exists at a point around the line segment formed by the vector between the edge (xedge, yedge) and also the skeleton (xskel, yskel) is scaled by a factor, a, and around the line segment formed by the vector between two consecutive points around the transverse edge (xtrans1, ytrans1) (xtrans2, ytrans2), scaled by a aspect, b (shown in Fig 10D). Supplied that the two vectors will not be parallel, thePLOS A single | DOI:ten.1371/journal.pone.0133088 July 24,16 /Automated Analysis of Block Copolymer Thin Film Nanopatternsequations[77] for the scalars, a and b, are: d ? trans2 ?xtrans1 yskel ?yedge ?? skel ?xedge ytrans2 ?ytrans1 ?a ?d ? xedge ?xtrans1 ytrans2 ?ytrans1 ?? edge ?ytrans1 xtrans2 ?xtrans1 b ?d ? xedge ?xtrans1 yskel ?yedge ?? edge ?ytrans1 xskel ?xedge  ?0??1??2?An intersection is regarded valid when 1 title= pnas.1107775108 pixelation on the lines. The labels 1, two, 3, and 4 mark the line topic to each and every from the four stages of smoothing described.